Jata JBSC1070 Instrucciones De Uso página 8

• Manipulation or replacement of any component must be performed by
an authorized service centre.
• Do not direct the airflow to the eyes or any other sensitive area.
• VERY IMPORTANT: Do not immerse in water or any other liquid.
• Do not use this appliance near the water contained in bathtubs,
washbasins or other containers.
• When used in a bathroom, disconnect after use. The proximity of water
represents a danger even when the dryer is off.
• To ensure a complementary protection it is advisable to install in the
electrical circuit of the bathroom a residual differential current device
(DDR) of differential current of assigned capacity that does not exceed
30 mA. Ask your supplier for advice.
• Allow it to cool before storing.
• This appliance is designed for domestic use only.
• The cleaning and maintenance done by users, can not be done by
children without any supervision.
• If the power cord is damaged, it must be replaced by the manufacturer
or by its after-sales service or similar qualified personnel in order to
avoid a danger.
INSTRUCTIONS OF USE
• The hair dryer has two switches and one pusher that control the heat and the airflow.
• Connect the appliance to the mains. To do so remove the cable.
• Push the power switch (4) to any of its two positions (
• Then press the power switch (3) to the desired position (I - II - III):
- I: Power 1.
- II: Power 2.
- III: Power 3.
• The combination of both switches will give you a wide range of options as to the airflow and the heat of the air.
• If you wish to use only colder air while it is on, press the cold air pusher (2). Release it to get hot hair.
• The air concentrator (6) and the diffuser (7) are placed in the mouth of the dryer by pressure.
• Once the work is finished, switch off the appliance , unplug it from the mains and put the cable away by
pressing the pusher (8). It is advisable to hold the plug in your hand to avoid accidents.
• Turn anti-clockwise to remove the grid of the diffuser and remove all the impurities.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning disconnect the appliance from the mains.
• You may clean it with a damp cloth and dry carefully afterwards.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of
the appliance.
• It is very important to keep the air intake (1) and outlet grids always clean.
ó ) to obtain a greater or lesser airflow.
8