Jata BT795 Instrucciones De Uso página 10

• Do not use the blender on empty.
• Don't allow children play with the appliance. Keep the
appliance out of the reach of children.
• Do not remove the jug with the food until the blade is totally
stopped and the appliance has been switched off.
• Make sure neither the appliance nor the cables are in direct
contact with hot surfaces or objects.
• Always place it on a flat surface.
• Always disconnect it from the mains when you do not use it
and before assembling / disassembling or when cleaning.
• There are risks of injury in case of improper use. You must
be careful when handling the cutting blades, when the jug is
empty and during the cleaning.
• The cleaning and maintenance done by users, can not be done
by children.
• If the power cord is damaged, it must be replaced by the
manufacturer or by its after-sales service or similar qualified
personnel in order to avoid a danger.
INSTRUCTIONS OF USE
• Screw the jug (3) in the blade block (6) by turning it clockwise.
• Next, fix it into the main body (4) making coincide the flange with the mark
making coincide it with the
• Pour the food in the jug and place the lid on it. Make sure the blender is perfectly closed.
• Turn the speed selector (5) clockwise to the desired position (1, 2 or 3). The blender will begin to work
maintaining the selected speed.
• It is advisable to begin at the lowest speed of the blender to later raise the highest speed if necessary.
However, and depending on the texture of the food, you may use the highest speed from the beginning.
• The position (P) is ideal to crush the ice. Turn the button and release the selector repeatedly for periods of
about 2 seconds to get crushed ice. For it, we suggest to use little ice cubes, or you can bit them before put
them on the blender, to avoid the "igloo" effect. This means that the crushed ice gets adhered to the blender
walls, and it impede that the other ice cubes arrive to the base to be crushed.
• You may add ingredients to the jug while in use without open the lid. During operation of the mixer, ingredients
may be added without removing the lid. To do this, remove the stopper (1). Slowly add the ingredients through
the opening in the lid and place the cap again.
• Once you have finished, set the speed selector to its "0" position and wait for the blade to stop turning
completely before removing the jug.
, you will listen a click. If necessary, turn slightly the gear of the main body (4).
10
, with the , and turn it till