DeLOCK 62661 Manual Del Usuario página 5

English
Package content
• Dual Docking Station
• USB 5 Gbps cable
• External power supply 12.0 V / 3.0 A
• User manual
Safety instructions
• Protect the product against moisture
• Protect the product against direct sunlight
• Pay attention that the HDD can be hot when it is connected to the device.
Installation of the Docking Station
1.
Start your Computer.
2. Connect the power supply to the DC jack of the docking station and connect
the power supply to the socket-outlet.
3. Plug the USB cable to the Docking Station and to a free USB port of your
computer.
4.
Insert your 2.5" or 3.5" HDD into one of the slots of the Docking Station.
5.
Switch on the Docking Station.
6. The HDD will be recognized by your computer as a drive and is ready to use.
If necessary you may need to set or partition your drive through the data
manager.
Clone Function
Note:
Make sure that the hard drive to which you want to transfer the data has the
same or higher capacity than the hard drive from which you want to copy.
All data which are on the target HDD will be overwritten during the copy
procedure! Therefore we recommend to save the old data before or to use an
empty hard drive.
Clone Function without PC
1. Connect the power supply to the DC jack of the docking station and connect
the power supply to the socket-outlet.
2.
Insert the HDD from which you want to copy the data into slot A (Source).
3. Insert the HDD on which you want to save the data into slot B (Target).
4. Switch on the Docking Station.
5. Press the Clone button for about 3 sec. in order to activate the function.
Press the Clone button again to activate the Clone process.
-5-