Publicidad
Idiomas disponibles
Idiomas disponibles
This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground
outlet with three-prong. Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded. When a standard 2-prong
wall outlet is encountered, it is your responsibility and obligation to have it replaced
with a properly grounded 3-prong wall outlet.
The cord should be secured behind the appliance and not left exposed or dangling
to prevent accidental injury.
The appliance should always be plugged into its own individual electrical outlet
which has a voltage rating that matches the rating label on the appliance. This
provides the best performance and also prevent overloading house wiring circuits
that could cause a fire hazard from overheated. Never unplug the appliance by
pulling the power cord. Always grip the plug firmly and pull straight out from the
receptacle. Repair or replace immediately all power cords that have become
frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion
damage along its length or at either end. When moving the appliance, be careful
not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly
recommended that you do not use an extension cord with this appliance. However,
if you must use an extension cord it is absolutely necessary that it be a UL/CUL-
Listed, 3-wire grounding type appliance extension cord having a grounding type
plug and outlet and that the electrical rating of the cord be 115 volts and at least
10 amperes.
SURGE PROTECTOR
Most electrical appliances use a series of electric control boards to operate. These
boards are very susceptible to power surges and could be damaged or destroyed.
If the appliance is going to be used in an area or if your city / country is prone to
power surges / outages; it is suggested that you use a power surge protector for
all electrical devices / appliances you use. The surge protector that you select must
have a surge block high enough to protect the appliance it is connected to. If you
have any questions regarding the type and size of surge protector needed contact
a licensed electrician in your area.
Damages due to power surges are not considered a manufacturer covered defect
and will void your product warranty.
OPERATION
CUATION: DO NOT USE BOILING WATER BECAUSE IT MAY DAMAGE THE PLASTIC
PARTS. IN ADDITION, NEVER USE A SHARP OR METALLIC INSTRUMENT
TO REMOVE FROST AS IT MAY DAMAGE THE COOLING COILS AND WILL
VOID THE WARRANTY. WE RECOMMEND USING THE PLASTIC SCRAPER
PROVIDED WITH YOUR UNIT.
NOTE:
IF THE UNIT IS UNPLUGGED, HAS LOST POWER, OR IS TURNED OFF, YOU
MUST WAIT 3 TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU
ATTEMPT TO RESTART BEFORE THIS TIME DELAY, THE REFRIGERATOR-
FREEZER WILL NOT START.
SETTING THE TEMPERATURE CONTROL
To control the internal temperature, adjust the control dials according to the
•
ambient temperature or purpose of use.
The first time you turn the unit on, set the temperature control to "7".
•
3
CHEST FREEZER
The range of the temperature control is from position "1" the warmest
•
to "7" the coldest in the freezer section. After 24 to 48 hours, adjust the
temperature control to the setting that best suits your needs. The setting of
"4" should be correct for home or office refrigerator use.
NOTE:
Turning the temperature control to "OFF " position stops the cooling cycle
•
but does not shut off the power to the freezer.
Large amounts of food will lower the cooling efficiency of the appliance.
•
If you choose to change the thermostat setting, adjust thermostat control by
•
one numerical increment at a time. Allow several hours for temperature to
stabilize between adjustments.
DEFROSTING YOUR FREEZER
When? For the most efficient operation and minimum energy consumption,
•
defrost the freezer when the frost on the freezer walls is excessive or ¼ to
½ inch thick.
Choose a time when the stock of frozen food is low.
•
Remove the frozen food from the freezer and place it in a cooler to protect
•
the food.
Turn the thermostat knob to "OFF".
•
Unplug the freezer. The "POWER ON INDICATOR" light should be OFF.
•
During defrosting, the ice melts into the cabinet.
•
Remove the drain plug on the inside floor of the freezer by pulling straight
•
out.
Place a shallow pan outside drain outlet. The defrost water will drain out.
•
Check the pan occasionally so the water does not overflow.
•
Clean the interior of the freezer.
•
Replace the plug on the inside floor.
•
Reconnect electrical connection. The "POWER ON INDICATOR" light should
•
be ON
Reset the thermostat to desired setting.
•
Allow the cabinet to cool for one hour.
•
Return food to the freezer.
•
Defrosting usually takes a few hours. Leaving the door open will help speed the
process. Also, pouring warm water (not boiling) on the ice/frost will help speed
melting. If you must use a scraper- please use caution - it is very easy to damage
the freezer compartment and void your warranty.
THE FREEZER COMPARTMENT
This compartment is designed for the long-term storage of frozen food.
•
Storage time is up to three months.
The storage life of frozen foods varies and the recommended storage time
•
should not be exceeded. The instructions regarding the care of frozen foods
should be followed when defrosting the freezer.
Pre-packed commercially frozen food should be stored in accordance with
•
the frozen foods manufacturer's instructions for a three star frozen food
storage compartment or home freezer.
Place frozen food into the freezer as quickly as possible after purchase.
•
If there are instructions on the packet, carefully follow these instructions
regarding storage times.
The freezer door is susceptible to breaking due to excessive ice build up. Be
•
sure to defrost when the ice reaches ¼ to ½ inch thick.
A storage basket is provided for the organization of odd-shaped items. To reach
other packages in the freezer, just slide the basket to one side, or lift it out.
Publicidad
