Thermador An American Icon HMWB30 Manual Del Usuario página 10

Fix Duct to transition and seal with tape.
For both installation method:
10.Wiring the HOOD:
WARNIN G:
To Avoid Electrical Shock Hazard
Turn off power at the service
panel before wiring this unit.
120 VAC, 15 or 20 Amp circuit
required .
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE [S FITTED WITH AN
ELECTRICAL JUNCTION BOX WITH 3
WIRES, ONE OF WHICH (GREEN/YELLOW)
SERVES TO GROUND THE APPLIANCE.
A WARNIN G:
TO PROTECT YOU AGAINST ELECTRIC SHOCK,
THE GREEN AND YELLOW WIRE MUST BE
CONNECTED TO THE GROUNDING WIRE IN
YOURHOME ELECTRICALSYSTEM,AND IT MUST
UNDER NO CIRCUNSTANCES BE CUT OR REMOVED.
Failure to do so can result in death or
electrical shock.
Power supply conduit
« Remove the j-box cover as shown in
Figure 5.
« tf notalready done, install 1/2" conduit -
connector in j-box.
From a
« Run black, white, and green wires (#14 control |
AWG) according to the National Electrical panel |
Code or CSA Standards and local codes and
ordinances .
+ Connect black, white, and green wires from Figure 5
power supply to black, white, and green/
yellow wires in j-box respectively.
« Close j-box cover.
Final installation steps
|.Install grease filters, lamps and drip trays as
described in the Care & Use section of this
manual.
Note: Lamps are notsupplied, use ONLY 120
Volt, 50 Watt (maximum) 50° halogen light
made fora GU10 base, suitable for use in
open luminarie .
Turn power on at service panel.