Publicidad
Power cord
Triple joint
Water pool
Please be sure to use the accessories provided by our company to install this electric
water heater. This electric water heater can not be hung on the support until it has been
confirmed to be firm and reliable. Otherwise, the electric water heater may drop off from
the wall, resulting in damage of the heater, even serious accidents of injury. When
determining the locations of the bolt holes, it shall be ensured that there is a clearance
not less than 0.2m on the right side of the electric heater, to convenient the maintenance
of the heater, if necessary.
4. METHODS OF USING
●
First, open any one of the outlet valves at the outlet of the water heater, then, open the inlet valve.
The water heater gets filled with water. When water flows out of the outlet pipe it implies that the
heater has been filled fully with water, and the outlet valve can be closed.
During normal operation, the inlet valve shall be always kept open.
●
Insert the supply plug into the supply socket, the indicator will light up this time.
●
The thermostat will automatically control the temperature. When the water temperature inside the
heater has reached the set temperature, it will switch off automatically, when the water tempera-
ture falls below the set point the heater will be turned on automatically to restore the heating.
Cold
water
inlet
Hot
water
outlet
Mixing valve
HORIZONTAL INSTALLATION
NOTE
NOTE
Pressure relief valve
Water inlet valve
7
Shower nozzle
Water inlet valve
Running water pipe
(Fig.6)
Publicidad
