Profi Cook PC-FR 1269 H Manual De Instrucciones página 11

Function Buttons
• The buttons on the appliance are touch buttons. Touch
the buttons lightly with a finger to perform the function.
Each key press is confirmed with a beep.
• If you keep the button or
starts.
Setting the Temperature and Cooking Time
The buttons and are each present twice on the
control panel.
• With the button or above and below the symbol
to set the temperature (80 – 200 °C).
• With the button or above and below the symbol
to you set the cooking time (1 – 60 minutes).
• Temperature and cooking time are displayed alternately
on the display.
Operation
1. Make sure that the appliance is disconnected from the
mains.
2. Pull the deep-frying container out of the appliance by
the handle.
3. If necessary, place the sieve insert with the silicone
knobs in the appliance. Push the sieve insert all the way
down.
4. Push the deep-frying container back into the appliance.
It must audibly click into place.
5. Connect the appliance to a properly installed safety
socket. A beep sounds and all the symbols light up
briefly. Then only the button
6. Press the button to switch the appliance to standby.
The appliance is factory-set to a temperature of 180 °C
and 15 minutes.
7. We recommend preheating the appliance for about
3 minutes without cooking food. Set the required tem-
perature and cooking time to 3 minutes.
8. Press the button to start the cooking process.
9. When the time has elapsed,
The fan runs briefly to cool down the appliance. Then
5 beeps sound and the appliance switches to standby.
10. Pull the deep-frying container out of the appliance by
the handle.
11. Place the deep-frying container on a heat-resistant
surface.
12. Fill the deep-frying container with the desired food.
13. Push the deep-frying container back into the appliance.
It must audibly click into place.
14. Press the button to switch the appliance back to
operating mode.
15. Set the desired temperature and cooking time. Alter-
natively, select an automatic programme (see next
chapter).
16. Press the button to start the cooking process.
17. If necessary, shake the food halfway through the cook-
ing time. To do this, pull out the deep-frying container by
PC-FR1269H_IM
Automatic Programmes
pressed, a quick run
• Select the automatic programmes by repeatedly press-
• The automatic programme "Keep warm / Defrost" is
• The following table shows the factory preset tempera-
• The preset temperature ( ) and cooking time ( ) can
• Also observe the information on the food packaging.
lights up.
Interrupting Operation
• Pull out the deep-frying container to interrupt operation.
• Operation can also be interrupted by pulling out the
appears in the display.
• The appliance resumes operation at the interrupted
Ending Operation
1. When the time has elapsed,
2. You can also end operation prematurely by pressing the
3. Pull out the deep-frying container by the handle.
4. Put the food in a heat-resistant bowl.
5. Push the deep-frying container back into the appliance.
6. Unplug the appliance from the mains.
the handle. Then push the deep-frying container back
into the appliance. The appliance continues operation at
the interrupted point.
ing the button .
selected with the button .
tures in degrees Celsius (°C) and the minutes (min). The
pre-settings are only guide values. Depending on the
size and weight of the food, the temperature and time
may have to be adjusted individually.
be adjusted with the corresponding buttons
Mode
French fries
Ribs
Prawns
Chicken legs
Steak
Cake
Fish
Keep warm /
Defrost
Replace the deep-frying container to resume operation.
mains plug. Reconnect the mains plug to the socket to
continue operation.
point. This also applies in the event of a power failure.
The fan runs briefly to cool down the appliance. Then
5 signal tones sound and the appliance switches to
standby.
button .
and .
°C min
200 20
180 15
160 20
160 40
180 25
160 20
180 20
115 12
appears in the display.
11
29.08.23