Publicidad
Idiomas disponibles
Idiomas disponibles
•
To remove the hose hold the end of the hose, press the tab on
the connector and pull the hose out of the inlet.
•
Hold the flexible hose coupler and insert it into the larger
opening in the tube.
•
Connect the telescopic tube with the hose and the brush.
•
Extend the telescopic tube to the desired length.
•
Before you start vacuuming, extend power cord cable to suffi-
cient length and insert the plug into the wall socket. The yel-
low mark on the power cord indicates it is extended almost
all the way. When you see the red mark do not pull the power
cord any further.
•
Use the on/off button to turn on the appliance. When you
have finished using the appliance, press the on/off button to
turn off the vacuum cleaner.
•
Unplug the cord from the wall outlet.
•
Wind up the connecting cord by pressing the power cord re-
tract button. To do this hold the cord to prevent it from tan-
gling or bumping the plug on the vacuum cleaner housing.
•
Disconnect the suction attachment — cleaning head from the
tube and disconnect the telescopic tube from the hose.
•
Close the telescopic tube.
•
Use the symbols on the display as a guide. Press the plus but-
ton (increases the suction power) or the minus button (reduc-
es the suction power).
•
Fabric curtains (lowest setting)
•
Upholstery (sofa, highend carpets and rugs)
•
Hard floors (highest setting)
EN
•
Plain carpets
CLEANING AND CARE
Empty the dust bin
•
Unplug the power cord from the power wal outlet before
cleaning. Empty the dust container, when the vacuum cleaner
becomes louder or when the suction power has decreased.
Check if dust container is full after each use. If necessary,
empty the container.
•
Hold the dust container and the handle and press the release
button.
•
Remove the dust container from the appliance.
•
Open the top cover of the dust container, then empty the dust
into the waste bin.
If the vacuum cleaner loses power, check how full the container is. If
the dust container is not full, check whether the suction brush or the
hose or tube is blocked with large items stopping the air flow. After
removing any obstruction, start the appliance again.
Clean and replace the inlet filter
•
Before cleaning the filter, remove the power cord plug from
the wall outlet.
•
The filter shall be cleaned when there are visible stains on it,
wash the filter in warm water with no detergent. Use it only
when completely dry.
•
Always use the vacuum cleaner with a filter in place.
•
Failure to install the filter may result in motor damage.
1. Remove the filter by sliding it out of the guides upwards.
2. Clean the filter or replace with a new one.
3. Reinstall the filter by placing it back into the guides. Ensure the
filter is completely dry before inserting it.
CLEAN AND REPLACE THE EXHAUST FILTER
•
Before cleaning the filter, remove the power cord plug from
the wall outlet.
•
Clean the filter when it is clearly soiled. Shake dirt off the fil-
ter and then brush it with a soft bristle brush. Then rinse the
filter in lukewarm water and do not use any detergent. Do
not direct strong jet of water onto the filter. Use it only when
Note! Figures are for illustrative purposes only. Individual models
may vary.
8
Publicidad
