Descargar Imprimir esta página

Craftsman 917.773702 Manual Del Usuario página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
CAUSE
CORRECTION
PROBLEM
Doesnotstart
Loss of power
1. Dirty air filter.
2. Out of fuel.
3. Stale
fuel.
4. Water
in fuel.
5. Spark plug wire is
disconnected.
6. Bad spark plug.
7. Throttle control lever not
in correct position
(if equipped).
1. Dirty air filter.
2. Buildup of grass, leaves,
and trash under trimmer.
3. Too much oil in engine.
4. Walking speed too fast.
1. Clean/replace
air filter.
2. Fill fuel tank.
3. Drain tank and refill with
fresh clean fuel.
4. Drain fuel tank and
carburetor
and refill tank
with fresh gasoline.
5. Connect wire to plug.
6. Replace spark plug.
7. Move throttle lever to FAST
position.
1. Clean/replace
air filter.
2. Clean underside
of trimmer
and trimmer head.
3. Check oil level,
4. Trim at slower walking
speed.
Excessive
1. Lines uneven or broken.
1. Check trimmer lines.
Vibration
2. Loose nuts or bolts.
2. Check all hardware,
including
engine belts.
3. Damaged
trimmer head.
3. CheeWrepair
trimmer head.
Starter rope hard
1. Bent engine crankshaft.
1. Contact a Sears or other
topull
qualified service center.
Loss of head
1. Belt not driving.
1. Put belt on pulleys or
drive
replace belt if broken.
Hard to push
1. Handle height position
not
1. Adjust handle height
right for you.
to suit.
Poortrimming
1. Trimmer line length is
performance
too short.
2. Throttle control lever not
in correct position
(if equipped).
Trimmer head
does not
retain line
1. Trimmer line not
properly
installed.
2. Broken line retainer clip.
3. Incorrect size of
trimmer
line.
1. If line is worn or broken to
half original
length,
replace line.
2. Move throttle lever to FAST
position.
1. Follow instructions
in
Maintenance
section.
2. Replace string carrier plate
assembly.
3. Use .155 diameter
trimmer line.
16

Publicidad

loading