Descargar Imprimir esta página
WESTEK RFK200 Instrucciones
WESTEK RFK200 Instrucciones

WESTEK RFK200 Instrucciones

Juego de timbre inalámbrico para puertas

Publicidad

Enlaces rápidos

Wireless Door Chime Kit
This kit allows the homeowner to choose from
16 different tunes including various classical music,
holiday jingles, and happy birthday.
Transmitter Mounting Instructions:
1. Detach back panel by sliding screwdriver under
slot on corner.
2. Mount back panel with screws provided.
3. Reattach unit to back panel by snapping it into place.
4. Unit can also be mounted with double faced tape,
included.
5. Unit is weather resistant for outdoor use.
Battery Replacement for Transmitter:
1. Detach back panel by sliding screwdriver under
slot on corner.
2. Replace battery with 23A 12V alkaline battery.
3. Reattach unit to back panel by snapping it into place.
Unit Operating Instructions:
1. Plug receiver into any standard outlet.
2. Mount transmitter in desired location.
3. Press button on transmitter to ring doorbell.
4. To change the ring, press the center button on the
bottom of the receiver until you reach the desired tune.
5. Volume down button is located to the left, volume up
button is located on the right.
6. Should your doorbell ring without the transmitter
button being pressed, it may be detecting a signal from
a neighboring device. In this case, simply choose a
different channel code. Transmitter and receiver must
have the same code selected in order to function properly.
(To change channel, select A, B, C, or D on the back
of the receiver. Detach back panel by sliding screwdriver
under slot on corner. Select the same letter as the
receiver (A, B, C, or D). Reattach back panel.)
Limited One Year Warranty
AmerTac
warrants this product to be free from defects in
material and workmanship for a period of one year from the
date of purchase. AmerTac's obligations are limited to repairing
or replacing any defective unit and are effective only if such
units are returned within one year of the purchase date to
AmerTac, 250 Boulder Drive, Breinigsville, PA 18031. Warranty
void if damage is due to misuse or improper installation. In no
circumstance will AmerTac be liable for consequential or
incidental damages relating in any way to this product.
Garantie limitée d'un an
AmerTac™ garantit ce produit contre tout défaut de matériaux
et de main d'œuvre pendant une période de un (1) an à partir
de la date d'achat. Les obligations d'AmerTac se limitent à la
réparation ou au remplacement de tout article défectueux et
s'appliquent seulement si l'article est retourné dans l'année de
sa date d'achat à AmerTac, 250 Boulder Drive, Breinigsville,
PA 18031. AmerTac ne peut en aucun cas être tenue
responsable pour des dommages consécutifs ou accessoires liés
de quelque manière que ce soit à ce produit.
Garantía limitada de un año
AmerTac™ garantiza que este producto está libre de defectos
de material y mano de obra por un período de un año a partir
de la fecha de compra. Las obligaciones de AmerTac se limitan
a reparar o cambiar la unidad defectuosa y son efectivas sólo
si se devuelve en un lapso de un año a partir de la fecha de
compra a AmerTac, 250 Boulder Drive, Breinigsville, PA
18031. La garantía no será válida si el daño es causado por
mal uso o instalación inadecuada. En ningún caso AmerTac
será responsable por daños consecuentes
o incidentales relacionados en cualquier forma con este producto.
RFK200
channel select switch
Chime List
1. Ding Dong
2. Westminster Clock Chime
3. Happy Birthday
4. Jingle Bells
5. Deck the Halls
6. Frosty the Snowman
7. Hark! The Herald Angels Sing
8. La Cinquantaine
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate this equipment.
Cet appareil est conforme à la section 15 des règles de la FCC.
Son fonctionnement est soumis aux deux conditions suivantes :
1. Cet appareil ne doit causer aucune interférence nuisible.
2. Cet appareil doit accepter toute interférence reçue, y compris
celle qui pourrait causer un fonctionnement indésirable.
Énoncé de mise en garde de la FCC: Tout changement ou toute
modification sans l'accord exprès de la partie responsable de la
conformité pourrait annuler l'autorisation accordée à l'utilisateur
de se servir de cet équipement.
Este dispositivo cumple con la Sección 15 de las Normas de la FCC.
Su funcionamiento está sujeto a las siguientes dos condiciones:
1. Este dispositivo no debe causar interferencia dañina.
2. Este dispositivo debe aceptar toda interferencia recibida, incluida
aquélla que puede causar un funcionamiento no deseado.
Precaución de la FCC: Cualquier cambio o modificación no
aprobados expresamente por la parte responsable para el
cumplimiento podrían anular la autoridad del usuario para utilizar
este producto.
Questions?, ¿Preguntas? 201.661.9944
©2009 AmerTac™
250 Boulder Drive
Breinigsville, PA 18031.
www.amertac.com
Made in China/Fabriqué en Chine/Hecho en China
battery
mount back panel
channel select switch
volume up
ring
9. Gavotte by Gossec
10. Symphonie No.9 "Choral"
11. Scene
12. Love Story
13. Rhythm of the Rain
14. Spinning Song
15. Serenade by Mozart
16. Farandole by Bizet
volume down
I09-0097-A

Publicidad

loading

Resumen de contenidos para WESTEK RFK200

  • Página 1 RFK200 Wireless Door Chime Kit This kit allows the homeowner to choose from 16 different tunes including various classical music, holiday jingles, and happy birthday. Transmitter Mounting Instructions: 1. Detach back panel by sliding screwdriver under slot on corner. 2. Mount back panel with screws provided.
  • Página 2 RFK200 Kit de carillon de porte sans fil Ce kit permet au propriétaire de choisir parmi 16 mélodies différentes, notamment de musique classique, de refrains de fête et de joyeux anniversaire. Instructions de montage de l’émetteur : 1. Séparer le panneau arrière en glissant un tournevis sous la fente du coin.