Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: The safety strap must be attached to the bike frame when using the Bike Trailer in
trailermode.
STEP 8. USING THE 5 POINT SAFETY HARNESS
WARNING: To avoid serious injury children should always wear the seat belt, shoulder straps and
a helmet.
BEFORE EVERY USE
1.
Make sure all parts are in goood working order and none are missing.
2.
Do not use the Bike Trailer if any parts are worn or missing.
3.
Check all fastners are securely tightened.
4.
Check all tyres to ensure they are properly inflated.
5.
If you have any questions about proper use please contact the qualified technician.
USING THE PRODUCT
SEAT FOR ONE CHILD
1. Undo the lap buckle and seat the child in the centre of the the Bike Trailer. Buckle the left belt over the childs
lap and pull the strap until the belt is snug. Place the two centre shoulder straps over the childs shoulders and
clip both straps into the D ring of the centre of the crotch strap. Adjust the shoulder strap height according to
the height of the child and then pull the straps until they are snug.
SEATING FOR FOR TWO CHILDREN
1. Undo the lap belt buckle and seat the children side by side in the Bike Trailer. Buckle the lap belt over both
children's laps and pull the strap until the belt is snug (there is only one lap belt for both children). Place one
outer pair of shoulder straps over the shoulders of the child seated on that side. Now clip both straps into the
D ring of the outer crotch strap directly below. Adjust the shoulder strap height according to the height of the
child. Then pull the straps until they are snug.
WARNING: The centre crotch strap will not be clipped to any shoulder straps
Important: adjust the straps so that the crotch strap and shoulder straps meet at the children's
stomach level. NOT AT CHEST LEVEL.
FOLDING AND STORAGE
1.
Unclip the tow bar safety strap from the D ring and remove the pin and hitch from the bike frame.
2.
Clip the end of the strap back onto the tow bar D ring.
3.
Remove the flag and pole and separate into 3 sections.
4.
Remove the screw cap from the rear axles of the rear wheels.
5.
Remove the quick release pin from the tow bar bracket at the front corner of the Bike Trailer.
6.
Fold the tow bar back under the Bike Trailer and replace the quick release pin through the tow bar and
U channel.
36
Publicidad
