Publicidad
Idiomas disponibles
Idiomas disponibles
Hold the tool with both
hands while starting the
tool, since torque from the motor can cause
the tool to twist.
On-Off Switch
(Fig. 6)
To switch the tool on, push the Switch Lock-off
10 forward. Then squeeze the Paddle Switch
11. To turn the tool off, release the Paddle
Switch 11.
Start the tool before applying to a workpiece,
and let the tool come to the desired speed
before contacting the workpiece. Lift the tool
from the workpiece before releasing the Paddle
Switch 11. DO NOT turn the switch "ON" and
"OFF" while the tool is under load. This will
greatly decrease the switch life.
Fig. 6
ON
10
OFF
Speed Selection
(Fig. 7)
Press the Speed Selection Buttons 7 to select
the desired speed. The selected speed will be
displayed on the LED Indicator Lights 6 as a
white light. See the table below for the speed
for each setting.
LED Indicator
1 x continuous white light
2 x continuous white light
3 x continuous white light
4 x continuous white light
5 x continuous white light
GWG12V-20S Die Grinder OSI Final for Approval 20230627.indd 14
GWG12V-20S Die Grinder OSI Final for Approval 20230627.indd 14
Operation
Fig. 7
LED Indicator Lights
Battery Charge LED Indicator Lights
(Fig. 7)
The 5 LEDs of the LED Indicator Light 6 indicate
11
the state of the battery charge, as listed in the
table below. After start-up, the LED Indicator
Light 6 will light up for 5 seconds.
LED Indicator
5 x continuous green light
4 x continuous green light
3 x continuous green light
2 x continuous green light
1 x continuous yellow light
Max Speed
(RPM)
1 x continuous red light
5,000
7,500
10,000
12,500
15,000
-14-
7
6
Capacity
80-100%
60-80%
40-60%
20-40%
1-20%
0-1%
6/27/2023 10:52:42 AM
6/27/2023 10:52:42 AM
Publicidad
