Publicidad
Idiomas disponibles
Idiomas disponibles
cAutIon – hIgh voluME lEvElS wIth AudIo productS!
This equipment is intended for professional use. Therefore, commercial use of this equipment is subject to the
respectively applicable national accident prevention rules and regulations. as a manufacturer, adam Hall is
obligated to notify you formally about the existence of potential health risks.
Hearing damage due to high volume and prolonged exposure: When in use, this product is capable of produc-
ing high sound-pressure levels (sPl) that can lead to irreversible hearing damage in performers, employees,
and audience members. For this reason, avoid prolonged exposure to volumes in excess of 90 dB.
cAutIon! IMportAnt InForMAtIon About lIghtIng productS
1.
Do not look into the beam from a distance of less than 40 cm.
2.
Do not stare into the beam for extended periods at short-to-medium distances.
3.
Do not view the beam directly with optical instruments such as magnifiers.
4.
Under some circumstances, stroboscopic effects may trigger epileptic seizures in sensitive individuals!
For this reason, persons who suffer from epilepsy should always avoid places where strobe lights are
used.
6
uSEr'S MAnuAl
ScopE oF dElIvErY
PWT06 power supply with strain relief bar
Power cord
6 x 1m DC cable
6 x y DC cable (current splitter and doubler)
Manual
connEctIon And StArt-up
Connect the PWT06 to the mains using the included ieC cord. Make certain that the voltage selection switch
of the PWT06 is set to the available mains voltage.
The PWT06 features six separate, isolated outputs for connecting the devices that you want to supply with
voltage. For this, use the included DC cables. each output delivers a maximum current of 1000ma (1a). Before
using this equipment, make certain that the correct output voltage (9, 12 or 18 vDC) is selected and the polar-
ity is set correctly.
noTe: We recommend noT moving the rear panel switches for setting the polarity and output voltage during
operation. The PWT06 is sufficiently protected against inadvertent adjustment during operation; however, con-
nected devices could be damaged by this.
uSIng thE Y cAblE
The power consumption of the connected devices must not exceed 1000ma. The included y cables can be
used to connect two devices to one output; for this, the power consumption of the two devices together must
not exceed 1000ma.
IMportAnt – do not MErgE outputS!
never use the Y cable in the reverse direction to merge two outputs. this can result in inter-
ference noise and damage to the device.
Strain relief bar
The strain relief bar is used to secure the connecting cables. you can wind the cables around the bar or fasten
them with cable ties.
7
Publicidad
