Hatco GLOMAX HLC5 Serie Instrucciones Originales página 8

MAINTENANCE
Replacing an LED Light Assembly
GLOMAX Curved Display Lights have two LED light assemblies
®
that illuminate the area below. These light assemblies have
special covers to guard against injury and food contamination
in the event of breakage.
To replace an LED light assembly:
1. Turn off the unit, allow the unit to cool, and disconnect the
power supply at the circuit breaker.
2. Unscrew the wiring access panel screws to remove the
wiring access panel.
3. Disconnect the LED wire lead connectors.
4. Release and remove the LED light assembly from the
retaining clips.
• At each retaining clip location, grasp the inside edge of
the light assembly, and carefully pull the assembly down
and out of the clip.
5. Position the new LED light assembly in the unit, and
carefully snap it into each retaining clip.
6. Connect the new LED light assembly wire leads to the wire
connectors.
7. Tuck the LED wire leads neatly up into the space between
the light assembly and the LED control box.
8. Re-install the wiring access panel using the screws.
TROUBLESHOOTING GUIDE
WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Unit is turned "On" but there is
no light.
Light is inadequate.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco for
assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com, select the Support pull-
down menu, and click on "Find A Service Agent"; or contact the Hatco Parts and Service Team at:
Telephone: +1-414-671-6350
e-mail: support@hatcocorp.com
Probable Cause
No power to unit.
LED light assemblies defective.
Switch is defective.
Wiring is open.
Unit mounted too high above target area.
LED light assembly defective.
Incorrect power supply (low).
NOTE: Hatco LED light assemblies meet standards for food
holding and display areas. For replacement LED
light assemblies part numbers, refer to the HLC5
Series Replacement Parts List on the Hatco website
(www.hatcocorp.com).
Wiring
Access
Panel
Wire
Lead
Replacing an LED Light Assembly
ELECTRIC SHOCK HAZARD: Turn OFF power switch and
unplug power cord/turn off power at circuit breaker before
performing any cleaning, adjustments, or maintenance.
Corrective Action
Check circuit breaker/power cord and reset/plug in, if necessary.
Replace LED light assemblies. Refer to procedure in
MAINTENANCE section.
Contact Authorized Service Agent or Hatco for assistance.
Lower unit, putting effective light closer to target.
Replace LED light assembly. Refer to procedure in
MAINTENANCE section.
Check power supply to unit, making sure it matches rating on
the unit. If power supply is incorrect, change to match rating
on unit.
8
Wire Connector
LED Light
Assembly
WARNING
Form No. HL5CEM-0420