Publicidad
Idiomas disponibles
Idiomas disponibles
4. Appliance description
Shiatsu neck massage device (front)
1
3
5. Start-up
• Remove the packaging
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply. The switch must be set to "0".
• Route the cable safely so that there is no risk of anyone tripping over it.
6. Operation
Use the switch on the side to switch on the massage device. The switch positions „I" and „II" also deter-
mine the massaging direction:
• Switch position I: the massage heads rotate against each other in an upward motion.
• Switch position II: the massage heads rotate against each other in a downward motion.
Move the switch to the middle position (level 0) to switch the device off.
The width of the massage heads can be adjusted. Use the adjusting wheel to set the required distance.
Adjust the massage heads only with the device switched off to prevent damage.
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device
for longer can over-stimulate the muscles and cause tension instead of relaxation.
WARNING
• The massage must be pleasant and relaxing at all times.
Stop the massage or change the position of the massage device if you find it is painful or
unpleasant.
• In order to prevent yourself from being trapped between the heads, do NOT lean on the
massage heads when changing your position or moving the massage device.
• Do not jam or force any part of your body, in particular your fingers, between the rotating
massage heads and their mountings in the device.
1: Two rotating massage heads
2
2: Switch, 3-level
• Level 0: Switch massage device OFF
• Level I and II: Select massage direction
3: Wheel for adjusting the width of the massage heads
4: Power plug
4
11
Publicidad
