APLIC 301836/20201022GZ019 Manual Del Usuario página 14

• To enable these functions again, you have to connect the
cables accordingly. To enable the settings, it is necessary to
switch the power supply on and off once again.
• It is advisable to install the sensors at a distance of about
50-70cm from the ground (ideally about 55cm)! The exter-
nal sensors should be installed about 15-20cm from the
outer edge of the bumper. The distances between the re-
spective sensors should ideally be between 24 and 40cm in
this case. Note: Ensure that the sensors are installed on a
flat surface of the bumper.
• The sensors A, B, C and D need to be installed from left to
right. In this case, the sensor A has to be installed in the
leftmost position, sensor B in the middle to the left, sensor
C in the middle to the right and sensor D in the rightmost
position.
14
English