Publicidad
Idiomas disponibles
Idiomas disponibles
SETTING UP THE SCREEN
STEP 1:
Place the screen vertically on the tripod feet and
release the tensioning lever on the carrying handle.
STEP 2:
Hold the screen by the handle and lift the case
slightly while pulling the tripod feet downwards as
far apart as possible and place the screen on them.
For sizes over 200cm, 2 people are required to set
up the screen.
STEP 3:
Hold the screen by the carrying handle and rotate
the stand 90° so that the screen can be extended
upwards. Adjust the housing to the desired height
and tighten the tensioning lever. Do not release the
housing by the carrying handle until the tension lever
is tight.
STEP 4:
Loosen the tensioning nut, turn the stand hook forward
and carefully pull the cloth vertically upwards. Hang
the fabric on using the loop in the centre of the upper
bar.
STEP 5:
With one hand, grasp the back rod of the stand, with the other hand the
carrying handle and adjust the screen to the desired height. Then screw the
tensioning nut hand-tight again.
STEP 6:
The integrated keystone bracket is located at the
top of the stand rod. This can be used to correct for
angled projection if required.
5
Publicidad
