Tascam MA-BT240 Manual Del Usuario página 13

Preparation
Connecting Euroblock plugs
2.5 mm or less
Terminal screw
Cable band
Euroblock plug tab
1.
Loosen the Euroblock plug terminal screws.
NOTE
Use a flat-blade screwdriver with a width of 2.5mm or
less.
2.
Insert wires.
NOTE
The wires that are compatible with the included Euroblock
plugs are AWG12–AWG22 for speaker output and AWG16–
AWG28 for mic input and REMOTE.
Using wires within the compatible range, trim about 7 mm
of the protective sheaths from their ends.
3.
Tighten the Euroblock plug terminal screws.
NOTE
Confirm that the wires cannot be pulled out.
4.
Use an included wire band to attach the wires to the
Euroblock plug tab.
Flat-blade screw-
driver
Euroblock plug
Attaching the Bluetooth antenna
Before connecting to a Bluetooth device, follow these procedures
to attach the included Bluetooth antenna.
Nut
Bluetooth antenna
Bluetooth antenna connector
1.
Attach the included Bluetooth antenna to the Bluetooth
antenna connector.
2.
Turn the Bluetooth antenna nut to secure it to the
antenna connector.
3.
Raise the Bluetooth antenna.
ATTENTION
o Use the included antenna, which was designed for use
with the MA-BT240.
o Be careful to bend the antenna in the correct direction.
o Do not forcefully bend the antenna.
Elongating the antenna
The antenna can be elongated by using a commercially-available
cable with an RP-SMA connector.
o For the antenna cable, use one with 50Ω impedance that
is 20 m or less.
ATTENTION
Even when elongating the antenna, use the included one,
which was designed for use with the MA-BT240.
TASCAM MA-BT240
13