Operation - Hitachi C 7D Manual De Instrucciones

English
2. Adjusting the angle of inclination
WARNING:
As shown in Fig. 15 by loosening the wing
bolt (A) on the inclined gauge, the saw
blade may be inclined to a maximum
angle of 45° in relation to the base. Always
insure that the wing bolt (A) is thoroughly
tightened after making the desired
adjustment.
NOTE: Values of the inclined gauge pro-
vided on the base merely serve as
a rough guideline. For cutting
operation at an inclined posture,
use the circular saw after adjust-
ing the angle between the base
and the saw blade with a protrac-
tor, etc.
3. Regulating the guide (Rip Fence)(Fig.
16)
................................. Optional Accessory
The cutting position can be regulated by
moving the guide to the left or right after
loosening its wing-bolt. The guide may
be mounted on either the right or left side
of the tool.

OPERATION

WARNING:
Never touch the moving parts.
Never operate the circular saw with the saw blade turned upward or to the side.
Do not fix and secure the switch lock. Besides, keep your finger off the switch trigger
when the circular saw is being carried around. Otherwise, the main body switch can
be inadvertently turned ON, resulting in unexpected accidents.
Keep the light ON during cutting operation only. If it is lit ON in other cases, the main
body switch can be inadvertently turned ON, resulting in unexpected accidents.
22
If the wing bolt (A) is
loose, injury can result.
Tighten it securely after
adjustment.
Inch Scale
Fig. 14
Wing-Bolt
(A)
Fig. 15
Wing Bolt, Lock spring
Fig. 16
Metric Scale
Inclined
Gauge
Base
Guide
(Rip Fence)