Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY WARNINGS FOR LAMINATE CUTTER
WARNING
• Always wear safety glasses when operating this tool
• Keep cutting blade in the fully closed position when not in use
• Keep fingers and hands away from blade cutting area
• Periodically check that all hardware remains tight
ASSEMBLY INSTRUCTIONS FOR LAMINATE CUTTER
1.
Attach the blade (A) to the cutter base (1) using the two nylon spacers (13) and double
threaded shaft (17, 18 & 19) as shown in the parts diagram.
2.
To install the backstop (16), align the open slot on the backstop to the slot on the cutter
base. Secure using the two provided screws (15).
OPERATING INSTRUCTIONS
1.
Place cutter on the floor making sure it is on a level surface.
2.
Mark the work piece to be cut and insert it against the backstop. The "V"-Support (21)
should be used to support the laminate while cutting.
3.
Always cut laminate with the finished side up. Place
the grooved or indented side of the laminate against
the backstop. (The "tongue" side should be closest to
the blade.) Begin the cut by holding the laminate firmly
with one hand and cutting into the laminate with the
blade approximately 1/2 in. You now have started your
cut. Proceed using both hands with a smooth powerful
downward motion to complete your cut.
4.
Remember the cut side will always be placed along the
wall to be covered up by baseboard or finish molding.
MAINTENANCE
• Keep cutter clean and store in a dry place when not in use
• Keep edges of blade sharp by using a sharpening stone
• Periodically check all assembly to ensure that hardware remains tight
2
Publicidad
