afx light HYBRID-360LED-FC Manual De Uso página 9

CONTROL CONNECTION (FIG4)
Connect the provided XLR cable to the 3-pin XLR output of your controller and the other side to the
male 3-pin XLR input of the moving head. You can chain multiple moving heads together through
serial linking. The cable needed should be 2-core, screened cable with XLR input and output connec-
tors. Please refer to diagram 4.
DMX512 CONNECTION WITH DMX TERMINATOR
For installations where the DMX cable has to run a long distance or is in an electrically noisy en-
vironment, such as in a discotheque, it is recommended to use a DMX termiantor. This helps in
preventing corruption of the digital control signal by electrical noise. The DMX terminaotr is simply
an XLR plug with a resistor connected between pins 2 and 3 which is then plugged into the output
XLR socket of the last fixture in the chain. Please refer to diagram 4.
INSTALLATION (FIG.3)
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety rope. Never stand directly below the device when mounting, removing or servicing the fix-
ture. This fixture may be mounted in any position provided there is adequate room for ventilation.
The LED moving head provides a unique mounting bracket assembly that integrates the bottom
of the base, the included 'omega bracket' and the safety cable rigging point in one unit (see illus-
tration 3).When mounting this fixture on a truss, be sure to use an appropriate clamp with the in-
cluded omega bracket using a M10 screw fitted through the center hole of the 'omega bracket'. As
an added safety measure, be sure to attach at least one properly rated safety cable to the fixture
using one of the safety cable rigging points integrated in the base assembly.
POWER LINK
Connect an IEC cable from the POWER OUT connector of the 1st unit to the POWER IN connector of
the second unit, etc.
CONTROL PANEL (FIG. 2)
To access the main menu press the MENU button. Press the UP or DOWN buttons until you reach
function you wish to change. When you reach the function you wish to change, press the ENTER
button. When a function is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button.
Tip: Press UP & DOWN buttons at the same time for 3 seconds. The display will reverse.
ARTNET FUNCTION
Art-Net uses a network protocol that greatly extends the use of DMX, simplifies cabling by using
RJ45 Ethernet cables and the possibility of using existing networks, HUBs and WIFI.
Art-Net theoretically allows the use of up to 32,768 universes, offering a huge range of possibili-
ties.
Connect an RJ45 cable to the RJ45 connectors on the rear panel, and the other end to your network.
FUNCTION MENU
MENU
DMX address
Channel Mode
DMX Mode
Auto run
Music run
A001-AXXX
22CH
20CH
Internal pro-
Master/Alone
gram 1-9
Internal pro-
Master/Alone
gram 1-9
WWW.AFX-LIGHT.COM
DESCRIPTION
DMX address setting
22 channel mode
20 channel mode
Auto mode
Sound controlled mode
9 EN