Husqvarna PG 280 S Manual Del Usuario página 12

3. Make sure that the motor has the correct direction of
rotation. The correct direction is shown with an arrow
on top of the fan cover.
4. If it is necessary, change the direction of rotation
of the motor. Refer to
rotation of the motor (3-phase only) PG 280 on page
12 .
To change the direction of rotation of the
motor (3-phase only) PG 280
1. Set the ON/OFF switch to 0 to stop the motor. Refer
To stop the product on page 12 .
to
2. Wait until the product has fully stopped.
3. Disconnect the extension cord from the power plug
on the product.
4. Turn the inverter switch in the power plug on the
product to the opposite position.
5. Connect the power cord and do a check of the
direction of rotation of the motor. Refer to
check of the direction of rotation of the motor PG 280
on page 11 .
12
To change the direction of
To do a
To start the product
1. Push down the handle lightly to lift the grinding
head from the surface, approximately 1 mm. This
decreases the pressure against the surface. Do not
lift the grinding head fully from the surface.
2. Set the ON/OFF switch to 1 to start the product. In
less than 5 seconds the product operates at the idle
ON/OFF switch on page 8 .
speed. Refer to
To stop the product
CAUTION:
the surface when you stop the motor. The
tool plate rotates for a while after the motor
stops. Much of the dust can blow off into the
air and the surface can be damaged.
CAUTION:
asphalt, paint or equivalent material, lift up
the front of the product slightly when the tool
plate stops. The product can attach to the
adhesive surface if it is not lifted.
1. Set the ON/OFF switch to 0 to stop the motor. Refer
ON/OFF switch on page 8 .
to
2. Keep the tool plate against the surface. Make sure
that the tool plate does not rotate before you lift up
the front.
3. Pull out the power plug.
-1 mm
Do not lift the tool plate from
If you grind adhesive
2112 - 002 - 24.10.2023