Mach Power EB-SMARTCHARGER16 Manual Del Usuario página 4

1. INSTALLATION
1.1 Wall installation
According to the size chart below, drill four holes in the wall, insert the bolt screws and install the
EB-SMARTCHARGER16.
ATTENTION
Make sure there is adequate structural strength to install the device. Inadequate resistance could
result in serious personal injury or equipment damage. It is the installer's responsibility to ensure
that the structure to which this system is installed can support five times the combined weight of all
equipment. It is advisable to reinforce the structure as required before installing the appliance. Use
the proper tools for the type of wall surface. Do not use in case of damage. Contact your dealer for
replacement or repair.
1.2 Floor installation
It is possible to position the cabinet directly on the ground, it is necessary to install four feet on the
lower surface to avoid damaging the cabinet.
1.3 Combo function
EB-SMARTCHARGER 16 is equipped with the COMBO function, which allows you to stack 2 charging
cabinets with 16 slots to transform them into a 32-slot cabinet.
4