Glacier bay KINCAID 60 Manual De Instalación página 14

NEXT STEP MAY REQUIRE TO TRIM THE SUPPORT BAR (E) AND ITS COVER (G)
If the support bar is too long for your wall-to-wall opening "D", you will have
to trim it down. Below calculation is for reference only: Ensure you made all
the proper measurements before you cut the bar.
1. Measure the distance "D" at the height where the bar (E) will be installed.
2. If D < 60 in, cut the bar (E) to a total length of L = D - 1/4 in.
3. After the bar (E) have been cut, cut the same length on the bar cover (G).
E
L
1
D
2
L = D - 1/4 in
3
G
PAGE 14