Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 28 Friday, December 15, 2023 2:25 PM
28 INSTALLATION
of the exhaust system is adequate for proper
operation of the appliance. This test should be
performed to alert you to any serious problems in
the exhaust system of your home.
• Your appliance features Flow Sense
innovative sensing system that automatically
detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint
buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
NOTE
• The appliance should be cool before starting this
test. If the appliance was warmed up during
installation, run the Air Dry cycle for a few
minutes to reduce the interior temperature.
Activating the Installation Test
1
Remove the drying rack and literature, and
then close the door.
• Do not load anything in the drum for this
test, as it may affect the accuracy of the
results.
2
Press and hold the Damp Signal and Wrinkle
Care buttons and then press the Power
button.
• This button sequence activates the
installation test. The code
the activation is successful.
3
Press the Start/Pause button.
• The appliance will start the test, which will
last a few minutes. The heat will be turned
on and the temperatures in the drum will be
measured.
4
Check the display for results.
• During the test cycle, monitor the Flow
TM
Sense
display on the control panel. If
Flow Sense indicator lights up when the
cycle ends, the exhaust system is adequate.
TM
, an
5
Check the Duct Condition
If the Flow Sense
exhaust system for restrictions and damage.
Repair or replace the exhaust system as needed.
NOTE
• When the appliance is first installed, this test
should be performed to alert you to any existing
problems with the exhaust duct in your home.
However, since the test performed during
normal operation provides more accurate
information on the condition of the exhaust duct
than the installation test, the results during the
two tests may not be the same.
• Do not interrupt the test cycle, as this could
result in inaccurate results.
• Even if the LED doesn't light up during the test
cycle, some restrictions may still be present in
the exhaust system. Refer to the Venting the
Dryer section of this manual for complete
exhaust system and venting requirements.
Error Codes
Check the error code before you call for service.
will display if
1Ns
Error
Code
tE1
tEz
Hs
If the exhaust system is severely restricted,
the display will lights up. Have the system
checked immediately, as performance will
be poor. Other problems may also be
shown with error codes. Refer to the the
Error Code table for details and solutions.
End of cycle.
• At the end of the test cycle,
The test cycle will end and the appliance will
shut off automatically after a short delay.
TM
LED is turned on, check the
Possible Cause & Solution
Temperature snesor failure.
or
• Turn off the appliance and call for
service.
Humidity sensor failure.
• Turn off the appliance and call for
service.
will display.
ENd
Publicidad
