Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEPS
Once the bed is on its final place
proceed as follows:
1) TORAC 2-section bed comes already
assembled and ready for use.
2) Plug in the bed to the mains supply.
SAFETY PRECAUTIONS
• The maximum allowed lifting limit is
arround 200 kg. Do not exceed this weight.
•Always ensure that the bed is used
within the correct electrical voltage
range. Unless otherwise requested, beds
are manufactured 220-240v rated and
should be used with the same rated supply.
• When the bed is placed for use, always
ensure that the power cord is in such
a way, that it will not get caught in the
moving parts or jammed under the wheels
of the bed (if fitted) or any other little
piece of furniture nearby.
· The bed is not recommended for wet
or high humidity environments such as
hydrotherapy rooms. Any prolonged
exposure to high moisture conditions
may affect the electrical components
and may result in failure.
•Always disconnect the bed from the
power supply before inspection. Children
are not allowed to use the bed or be near
the equipment while it is on use. Do not
leave children unsupervised near the
bed.
•Always take care to avoid anyone sitting
on the head or leg parts of the bed since
this will cause damage to the bed and
its electronic, hydraulic and mechanical
functions.
EN
BACKREST ADJUSTMENT
In the back part of the backrest there is a
lever. Press it to activate the gas lifts and
adjust the backrest angle up or down.
It can go from +90º to -23º.
HEIGHT ADJUSTMENT
In the base of the bed there is a metal bar,
wich you can access from both sides of the
bed.
The bar is adjusted with your feet. Hooking
your feet under the bar and pushing it up,
the bed will lower. Stop pushing to leave the
bed in your desired position.
To rise the bed, step on the bar and push
down until the bed rises to the desired
position, and then stop pushing.
Publicidad
