us_main.book.book Page 48 Friday, July 30, 2021 11:23 AM
48 TROUBLESHOOTING
Problem
Washer is not filling
Filter is clogged.
properly.
• Make sure that inlet filters on the fill valves are not clogged. Refer to Cleaning the Water
Inlet hoses may be kinked.
• Check that inlet hoses are not kinked or clogged.
Energy efficiency
• This is a High-Efficiency (HE) washer. As a result, the water level settings for this washer
Insufficient water supply
• Make sure that both hot and cold water faucets are turned on all the way.
Washer door is open.
• Close the door and make sure that nothing is caught under the door preventing it from
Water level is too low.
• The water will not normally cover the clothes. The fill level is optimized for the wash
Water in the washer
Drain hose is kinked, pinched, or clogged.
does not drain or
• Make sure that the drain hose is free of clogs or kinks and is not pinched behind or under
drains slowly.
The end of the drain hose is more than 96 inches (2.4 m) above the bottom of the
washer.
• Move the end of the drain hose so that it is lower than 96 inches (2.4 m).
Bleach does not
Bleach dispenser cover is not properly installed (on some models).
dispense.
• Make sure that the bleach cover is properly installed and snapped into place before the
Bleach dispenser is dirty or clogged.
• Lift out the bleach dispenser cover and clean out the reservoir. Lint and other foreign
Premature
Bleach dispenser filled for future load.
dispensing of bleach
• You cannot store bleach in the dispenser for future use. The bleach will be dispensed every
Overfilling the bleach dispenser
• Overfilling the bleach dispenser will cause the bleach to dispense immediately, which will
Inlet Filters in MAINTENANCE.
may be different than for conventional washer.
closing completely.
motion to achieve the best wash performance.
the washer.
beginning of the cycle.
debris that are collected inside the dispenser may prevent proper dispensing of the
bleach.
load.
damage the laundry or the washer. Always measure bleach, but never fill above the max
line on the dispenser. A half cup of bleach is sufficient for most loads. Never use more than
1 cup of bleach.
Possible Cause & Solution