Publicidad
Idiomas disponibles
Idiomas disponibles
ACCESSORIES
See Figures 9 - 11, page 10.
The supplied accessories perform a variety of functions and
can be used with or without the hose. The sport ball needle
can be used to inflate any type of sports ball or any other
item that requires an inflation sport ball needle.
NOTE: When inflating items of 10 PSI or less, inflate in short
bursts and check after each burst by feel or with a calibrated
measuring device to determine accurate pressure.
SPORT BALL NEEDLE
NOTICE:
Insert the sport ball needle only until its base is flush
with the surface of the air chuck. Do not insert the sport
ball needle all the way into the chuck. Installing the sport
needle incorrectly can damage the gauge, air chuck, or
other parts of the inflator.
The sports ball needle can be installed directly into the pump
outlet or used with the hose accessory.
„ Insert the sports needle ito the pump outlet or the air hose.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
NOTE: ILLUSTRATIONS START ON PAGE 9 AFTER FRENCH AND
OPERATION
MAINTENANCE
SPANISH LANGUAGE SECTIONS.
7 — English
„ Insert sport ball needle into sports ball valve and inflate.
„ Remove sport ball needle after inflation.
NOTE: Pressure required for most sports balls is too low for
accurate reading on tool gauge.
PRESTA VALVE ADAPTOR
The Presta valve adaptor can be used by installing directly
into the pump outlet, but it is recommended to be used with
the air hose. Before inflating a tire with a Presta valve, loosen
the locking nut on the valve stem to inflate. Once inflation
is complete, tighten the locking nut to seal the tire valve.
„ Loosen the Presta valve locking nut.
„ Thread the Presta valve adaptor onto the valve stem with
the larger open end toward the wheel.
„ Position the air chuck clamp in the unlock position.
„ Clamp the end of the air chuck down onto the Presta
valve adaptor by pressing air chuck clamp down until it
locks into place.
„ After inflation, remove air chuck and tighten locking nut.
MOUNTING STRAPS
„ Use the included hook and loop straps to mount the
inflator to the area desired.
NOTE: Ensure the inflator is securely mounted to desired
location.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
Publicidad
