GE PSA1200 Instrucciones De Instalación página 21

Installation Instructions
c3| ADAPTING BLOWER FOR
RECIRCULATION (continued)
|5 | Place the blower unit back into the opening.
AWARN ING risk of electric shock
can cause injury or death. Do not pull or stretch
the blower unit wiring. Make sure the wired are
not pinched.
6 | Secure blower unit to oven with the 2 screws
removed in Step 2. Insert the screw in bottom right
screw hole on the back of the oven.
Replace blower plate with the screws removed in
Step 1.
v @—— Blower Plate Screws
y i
t h
Back of Oven
Blower Motor
Screw
21
C4| MOUNT THE OVEN
ACAUTION: To avoid the risk of personal
injury (back injury or other injuries due to excessive
weight of the microwave oven) or property damage,
you will need two people to install this microwave
oven.
IMPORTANT: Do not grip or use handle during
installation.
AWARN I NG: risk of Electric Shock. Can
cause injury or death: If installing unit with metal
countertops, cover the edge of the power supply
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting
the microwave oven,
thread power cord through
hole in bottam of top
cabinet. Keep it tight
throughout Steps 1-3. Do
not pinch cord or lift oven
by pulling cord.
Lift microwave oven,
tilt it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting plate.
Rotate front of oven up
against cabinet bottom.