Publicidad
Idiomas disponibles
Idiomas disponibles
B
B
Utilisation de l'appareil
Using the appliance
Changing the door
Loosen the screws behind the top cover using a cross-head screwdriver and
A
remove the cover plate from the appliance.
Remove the screws from the upper hinge using a cross-head screwdriver.
B
Replacing the top hinge.
C
Replace the bearing shell on the door and the clamping plate.
D
Loosen the screws on the lower hinge using a cross-head screwdriver, replace
E
the hinge on the other side and attach with screws.
NOTE : The tilt angle of the appliance should be less
than 45 °.
Replace the levelling foot on the other side and adjust to make sure that the
F
unit is stable.
Position the door correctly and attach the upper hinge and the cover. Make
G
sure that the appliance is unplugged and empty. Adjust the two levelling feet in
their highest position.
Extended periods of disuse
Proceed as follows if the appliance is not being used for a long period of time:
1. Disconnect the appliance from the mains by removing the plug from the socket.
2. Clean and dry the inside of the appliance following the instructions in the section on cleaning
the appliance.
3. Leave the door open to prevent the accumulation of bad smells whilst the appliance is not
in use.
8
8
EN
FR
C
C
Informations pratiques
Useful information
Cleaning and maintenance
• Remove the plug from the power supply.
• Use a clean, soft sponge and a gentle detergent diluted with
lukewarm water.
• Do not use abrasive or aggressive cleaning products.
• Wash by hand, rinse and dry all the surfaces thoroughly.
• Do not use wax cleaners, concentrated detergents, bleach or
cleaning agents containing petrol on plastic and rubber parts.
• Never use kitchen roll, glass cleaning sprays, caustic
cleaning products or inflammable liquids on plastic parts as
these products could scratch or damage the material.
• Clean the appliance with a cloth soaked in this solution and
dry using a soft cloth.
9
9
EN
FR
Publicidad
