GE AEH18 Serie Manual Del Propietario Y Instrucciones De Instalación página 14

Window Installation instructions
[] iNSTALL THE AiR CONDiTiONER
iN THE CASE
I-_ Make sure the ground
wire is off to the side
and slide the air _i i
conditioner into the :_
case. Do not push
on the controls or the
finned coils. Make
sure the air
conditioner is
firmly seated.
[_ Reinstall the locking bracket and screw
removed earlier.
Reconnect the ground wire to the air
conditioner using the screw removed earlier.
IMPORTANT: The ground wire must be
reinstalled to ensure a proper ground.
®
%
Press the ground wire against the unit to
prevent it from being pinched when
installing the front grille
Remove the front grille from its box and
remove the shipping tape.
Grasp the inlet grille at the bottom corners
and pull it forward. Unhook it from its top
hinges and set it aside.
F-_ Using the tab, pull up slightly on the filter
to release it and pull it down and out.
14
iNSTALL THE AIR CONDITIONER
IN THE CASE (cont.)
Pull the coiled power cord from its shipped
position in the air discharge area. Attach the
front grille frame to the case by inserting the
tabs on the grille frame into the slots
on the front top of the case.
Guide the lever carefully
through the grille frame
as you push it in,
Press the grille frame in around the power
cord on the right side. Secure the grille with
a type F (painted) screw on each side and a
type C screw in the front.
Type F
screw
IT] Reinstall the filter.
Type F
screw
,/
\
Type C screw
[] Reinstall the inlet grille. Connect power.
Caulk or weather-strip any gaps or openings
to the outside to seal the installation.