HAMPTON BAY KZB1501HX-01/MB Guía De Uso Y Mantenimiento página 2

Assembly and Installation(continued)
3
Replace the bulb
Step1
Use the phillips screwdriver to unscrew the set screws (4)
□
from the top cover (1).
Remove the top cover (1) , shade cover (2) and the shade
□
(3), and then pull out the bulb (E).
Care and Cleaning
□
Clean the fixture with a soft dry cloth.
Troubleshooting
Problem Possible Cause
□
The fixture will There is no power.
□
not light.
There is a disconnection or break
in the wire.
□
The transformer setting is
incorrect.
□
The light flickers There is a loose wire connector to
(one fixture). the fixture.
□
The lights flicker There is a loose connection at the
(all fixtures). transformer.
Warranty
WHAT IS COVERED
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from date of purchase.
This warranty applies only to the original consumer and only to products used in normal use and service. If this product is found to be defective, the
manufacturer's only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer's discretion, provided that the
product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence,
alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion
of the product, such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specifically disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the
warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor / expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.HamptonBay.com
Step 2
Install the LED bulb (E) by pushing it in until it is secure.
□
Reinstall the shade (2), shade cover (2) and then the top cover (1) into place.
□
Use the phillips screwdriver to re-screw the set screws (4)
□
into the top cover (1).
□
Do not use any cleaners with chemicals, solvents or harsh abrasives.
Solution
□ Check the outlet and ensure that a breaker or GFCI circuit has not been tripped.
□ Follow the wires from the fixture and ensure a continuous connected path back to the
transformer.
□ Check the settings on the transformer.
□ Tighten the wire connector and ensure the metal contacts pierce the insulation on the
low voltage cable from the transformer.
□ Unplug the transformer from the outlet and visually inspect the positive and negative
connecting points. Each wire should be securely screwed in and not in contact with any
other.
2
.