Amica VM 7011 Manual De Instrucciones página 7

Do not use the vacuum cleaner without a dust bag and/or filters.
If the opening, which sucks air, hose or telescopic tube are clogged,
you should immediately turn off the vacuum cleaner Before restart-
ing the vacuum cleaner, first remove the blocking item.
Do not use the vacuum cleaner too close to heaters, radiators, cig-
arette butts, etc.
Before using the vacuum cleaner, remove sharp objects from the
floor to avoid damaging the dust bag.
Do not collect fine particles such as: flour, gypsum, printer toners,
etc., as this may clog filters and damage the vacuum cleaner.
Make sure that extension tube is fully withdrawn before you put
away your vacuum cleaner either in vertical or horizontal position.
SPECIFICATION:
Power specification:
Nominal power:
Maximum power:
Weight (without accessories)
Amica S.A. hereby declares that the type of radio wave emitting equip-
ment, Vacuum Cleaner, model VM7011 Sharq, VM7012 Sharq: com-
plies with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available on our web-
site at: www.amica.pl
Frequency bands
The maximum power of a radio signal
transmitted in a frequency band
YOUR APPLIANCE:
1. Motor unit
2. Turbo brush
3. Exhaust filter
4. Telescopic tube
5. Hose with a handle
6. Parquet brush
7. Universal 2­in­1 brush
8. Accessory holder
9. Bookshelf suction attachment
10. Upholstery nozzle
11. Crevice nozzle
2
3
11
4
5
6
OPERATE THE APPLIANCE:
Pair the hose with the vacuum cleaner
1. Insert the plug of the power cord into the power socket, press
the ON/OFF button to turn on the appliance, then simultaneously
press and hold the plus and minus buttons until the display flashes.
AC 230 V / 50Hz
700W
720W
8.6 kg
433.050­434.790MHz
<­35dBm
1
7
8
9
10
2. Then take the hose (ensure that batteries are installed in the vac-
uum tube handle) and press the ON/OFF switch. If the appliance
turns off, pairing is successful.
3. After successful pairing, use the handle to make sure that it op-
erates properly. Press the ON/OFF switch to turn off the appliance.
Assemble the appliance
• Insert the hose into to the vacuum cleaner body.
• To pull the hose out of the vacuum cleaner body, press the
two tabs on both sides and pull out the hose.
• Extend the telescopic tube to the desired length.
• Connect the telescopic tube to the hose handle. Insert the
brush into the other end of the hose.
7
EN