Mover-Technology CT 1500 Manual Del Usuario página 6

CAMPER TROLLEY
Congratulations on the purchase of your new Camper Trolley, and thank you for choosing a product
from Mover Technology.
We hope this product will bring you many years of satisfaction.
It is important that you read this manual thoroughly
before using your Camper Trolley.
Technical Data:
Battery voltage:
Batteri, spasnding:
Battery type:
Battery operating capacity:
Battery charger:
Battery remote control:
Max. load stress:
Speed unloaded:
Speed loaded:
Motor:
Safety function:
Solar cell:
Hauling capacity:
Caterpillar tracks:
Weight:
Contents of transport crate:
On unpacking the Camper Trolley, check that all parts are in the crate.
In case of missing content: Contact your dealer.
Operating Manual: 1 pee
Camper Trolley: 1 pee
Charger, 230 V 1.0 A: 1 pee
Remote control: 1 pee
Transportation bag: 1 pee
+ Suspension hardware, composed of the following parts:
Cotter ring: 1 pee
Stabilization pipe: 2 pee
Suspension fitting: 2 pee
Extension tube for fitting 1 pee
+ Screws and nuts for suspension fitting.
The EC Declaration of Conformity is available via the manufacturer.
Mover-technology ApS
Ved Stranden 1
9560 Hadsund - DK
14.4 V.
14.4 Volt
Lithium
Approx. 30 min. operation
230 V - 14.4 V. Capacity 1.0 A.
1 pee AA - 9.0 V.
500 kg.
Approx. 9 m./min.
Approx. 8 m./min.
2 pee 14.4 V planetary gear motors.
3 min. Auto shut-off.
18.0V1.17W.
Trailers up to 1500 kg.
2 pee with terrain rubber profiles.
36.38 lb.
10
I
Mounting the suspension fitting:
If there is a plastic cover over the side member system on the camping trailer, it can be helpful to
remove it while mounting the suspension fitting.
Extension tube for mounting fitting.
When mounting the suspension fitting from the Camper Trolley onto the camping trailer, start by
gliding the 2 stabilization tubes A1 and A2 together and placing them up inside the side members.
Next screw on the right and left fitting loosely (right and left are seen from the ball catch on the tow
bar).
Extension tube:
In case of larger distances between side members, place the extension tube inside the smallest
stabilisation tube.
The illustration below shows the placement of the suspension fitting mounted on the side members.
<3
Finally, slide the entire suspension fitting as far back on the side members as possible to put
maximum weight on the Camper Trolley. Do not push the suspension fitting so far back that
mounting and dismounting the Camper Trolley becomes difficult.
11