Main Components - SOLAC DC7500 Instrucciones De Uso

• Make sure the cord does not come into contact
with sharp edges or hot surfaces. Do not leave
the cord hanging over the edge of a table or
worktop, to prevent children from pulling it and
causing the appliance to fall.
• Remove all elements from the inside or outside
of the appliance used for protection during
transport or for sales promotions, such as paper
or plastic bags, plastic sheets, cardboard and
stickers.
• Never leave the appliance exposed to the
elements.
• Avoid splashing water on the charger or the
power cord.
• Do not touch the appliance with wet hands
when in operation.
• Do not use the appliance on wet surfaces or
outdoors.
• The appliance must be connected to a power
socket with a suitable ground connection.
• Do not use on sensitive areas such as
eyebrows, moles, warts, open wounds, cuts,
burns, etc.
• People insensitive to heat must be careful when
they use the device.
• Never use the appliance without wax. The
device is designed to melt and heat depilatory
wax, whether empty pot heats the device may
be damaged.
•Do not use with the lid on. The lid is
designed to prevent the accumulation of dust
when the machine is not being used. Melt wax
with the lid on, may cause damage to the
device.

2 MAIN COMPONENTS

1 Tapa
2 Filtro (intercambiable).
3 Cuba 1
4 Cuba 2
5 Piloto luminoso.
6 Controles de regulación de
temperatura.
7 Spatula
3 OPERATION
Use this appliance to remove hair from the
desired areas of the body. It is not advisable to
remove hair from the armpits and eyebrows at
home. This treatment should be left to a
beautician.
Hot wax hair removal has the advantage of
reducing the rate of hair growth.
To obtain an excellent result, hair should
be at least 2 to 3 millimetres in length and skin
should be clean without cream or talc.
1 Plug in the appliance.
2 Remove lid and pour the capsules of wax into
tub 1 (approx. 200 gr.).
3 Set the tub's temperature regulator to wax
melting mode (Fig. 1).
The light will then come on.
The temperature regulator of vat 2 will be
in the "stop" setting (Fig. 2).
4 Stir the wax now and again with the spatula.
5 When it has taken on the consistency of a thick
syrup. re-adjust the temperature regulator to hair
removal setting (Fig. 3). The light will go out.
After a few minutes the light will come on
again and the wax should be at a suitable
temperature for hair removal.
6 Mix the wax to ensure an even temperature
throughout.
7 Using the spatula place a little wax on the back
of your hand to test the temperature. If this is
suitable for you. you may begin hair removal.
Thanks to the thermostat, the temperature
of the wax will remain constant.
8 Run your hand along your legs using an
upward motion to flatten out the hairs.
9 Using the large spatula, spread out the wax in
strips of approximately 6 cm in length and 3 cm in
width.
Wax should always be applied in the
opposite direction to the growth of the hair.
10 Removing the wax
• Wait for 30 to 60 seconds until the wax strip
becomes dry to the touch.
• Hold your skin taut. Grasp the thicker end of the
wax, and pull the strip back as quickly as you
can, against the direction the hair grows (from
7
EN