Timbela M101 Manual Del Usuario página 14

Wooden garage M101
IMPORTANT!
Before starting to assemble your shelter, read the assembly instructions carefully. This will avoid problems
and wasted time. You can start the assembly after having identified, analyzed and grouped all the elements
making up your shelter. This manual also contains instructions for maintaining your shelter which will be
useful to you.
WARNING!!!
- Keep the packaging until the end of assembly in a dry place, but not in direct contact with the ground and
protected from atmospheric conditions (humidity, sun, etc.). Do not store the packaging in a heated room!
The materials used are natural products and their quality may change depending on climatic conditions,
despite the fact that the materials have been dried before treatment. When choosing the place to mount
your garden shed, make sure that the shed will not be subjected to extreme weather conditions (areas of
strong wind or heavy snowfall); otherwise you should fix the shelter to the ground (with anchor pieces for
example).
ADVICE BEFORE ASSEMBLY
SHELTER CARE WOOD TREATMENT BEFORE ASSEMBLY
An insecticide, fungicide and anti-termite treatment intended for the preventive and curative treatment of
exterior woods must be applied in 2 layers on all sides of the pieces of wood (floor included). For this
treatment the wood must be dry, two coats of treatment must be applied at temperatures above + 5 ° C.
After this treatment, and once the wood is dry, apply two coats of stain on all surfaces of the wood. The stain
will protect the wood while letting it breathe. The latter, colored or not, protects the wood from water and
UV rays. Pay particular attention to the angles, knots, slots and where the parts fit together when applying
the two treatments. It is advisable to apply a stain 2 shades superior to the shade of the essence of wood in
order to limit the speed of discoloration of the wood and the local appearance of traces of graying.
INSPECTION FORM
As soon as the packaging is opened, the components must be treated within 72 hours and assembly must
begin immediately after drying of the treatment applied, this to prevent the wooden planks from being
deformed. Before assembly we recommend to treat the beams twice all four sides of the board with an oil-
based protective product-to protect the wood from fungus, blackening, and insects. After assembly, a
14