Publicidad
Idiomas disponibles
Idiomas disponibles
Status LED Baby unit
The status LED above the on/off switch indicates the status of the baby unit.
Status LED
Power
Status
Green
on
device is switched on
Status LED parent unit
The status LED above the on/off switch shows the status of the parent unit.
Status LED
Power
Status
Green
on
device is switched on
flashing green (slowly)
on
batteries are charging
flashing green (rapidly)
on
noise is being received from the baby unit
red flashing
on
short flashing: maximum range is exceeded;
long flashing: batteries are flat
blue
on
ECO mode
red
off
batteries are charging
Battery operation
1
2
IMPORTANT: Only use rechargeable NiMH AAA batteries! Switch the units off and
disconnect the power lead before changing the batteries.
18
3
As soon as the batteries are too weak, the status LED in the switched on state begins to
flash red. If the device is not connected to a power supply, the connection will worsen
and eventually cut off automatically. Rechargeable batteries can be charged directly in the
baby monitor. To do this, connect the device to the wall power supply using the supplied
mains adapter. The batteries take approximately 10 hours to charge (with the device
switched off ).
This baby monitor is equipped with an optical and acoustic range control system. At
regular intervals, check the baby unit and the parent unit for two-way communication
(also in standby mode, if the baby unit is not receiving any noise). If the range is exceeded,
the status LED on the parent unit begins to flash red and an alarm tone sounds at regular
intervals.
As soon as you place the parent unit in a fixed location where you have already checked
the reception, we recommend that you switch on ECO mode (quickly press the ON/OFF
button 3 times). This will switch the unit to standby mode which involves lower power
consumption and radiation emission (if your child is asleep). The baby monitor only
transmits when it perceives noise. The range control is maintained in ECO mode.
Press the on/off switch briefly to activate the paging function of the baby unit. It triggers
an acoustic signal from the parent unit. This makes it possible to find the parent unit if it
has been misplaced.
To increase or decrease the receiver volume on the parent unit, press + (for louder) or - (for
down).
Battery operation
Range control
ECO mode
PAGING function
Volume control / parent unit
GB
19
Publicidad
