4. Pull the attachment straight out of the
coupling.
C
Introduction
WARNING:
understand the safety chapter
before you use the product.
Before you operate the product
•
Examine the work area to make sure that
you know the type of terrain. Examine
the slope of the ground and if there are
obstacles such as stones, branches and
ditches.
•
Do a general inspection of the product.
•
Do the safety inspections, maintenance
and servicing that are given in this manual.
•
Examine the motor for dirt or cracks. Use
a brush to clean the motor from grass and
leaves. Use gloves when it is necessary.
•
Examine the trimmer head and cutting
attachment guard for damages or cracks.
Replace the trimmer head and cutting
attachment guard if they are hit or if they
have cracks.
•
Make sure that all nuts and screws are
tight.
•
Make sure that all covers, guards, handles
and the cutting equipment are correctly
attached and not damaged before you start
the product.
To connect the battery charger
WARNING:
charger in ambient temperatures
between 41°F (5°C) and 104°F
(40°C).
2114 - 004 - 03.11.2023
Operation
Read and
Only use the battery
1. Connect the battery charger to the voltage
and frequency that is specified on the
rating plate.
2. Put the plug in a grounded power outlet.
The LED on the battery charger flashes
red 1 time and green 1 time.
To charge the battery
CAUTION:
battery, the battery charger and the
terminals on the battery are clean
and dry. Do not put the battery in
the battery charger if it is dirty or
wet.
1. Connect the battery charger to a power
outlet. The charging LED flashes red 1
time and green 1 time.
CAUTION:
battery charger to a power outlet
with the voltage and frequency
specified on the rating plate.
2. Connect the battery to the battery charger.
The charging LED comes on.
3. Remove the battery from the battery
charger when it is fully charged. Push the
battery indicator button for battery status.
When all the LED indicators come on, the
battery is fully charged.
4. Pull the power plug to disconnect the
battery charger from the power outlet. Do
not pull the power cord.
Make sure that the
Only connect the
15