Chapman DT100 Instrucciones página 3

Description
The DT100/FT100 Tipping Trailers are designed for equestrian, agricultural, contractors and other customers as an all round heavy duty, reliable
hydraulic tipping trailer. It's 1 ton payload is perfect for moving soil, dung, stone plus much more with ease and paired with a twin pivoting axle &
flotation tyres allows for easy towing off-road.
The DT100/FT100 is a trailed attachment, attaching to the towing vehicle with a 50mm ball hitch connection with integral overturn safety swivel
hitch. The DT100 is fitted with a unique automatic latch/unlatch system is installed in the rear tailgate, the FT100 comes complete with drop
down and removable sides. The DT100/FT100 is installed with an electric operated hydraulic system, complete with wired hand remote that
attaches to the back of your ATV, UTV of 4×4 and on-board battery for the ultimate convivence and approximately 50° tipping angle for hassle
free emptying.
These machines should however only be used to perform tasks for which they were designed - use of the machine for any other function may be
both dangerous to persons, and potentially damaging to components. Use of the machine beyond the stated usage may invalidate any applicable
warranty, as well as being potential in breach of applicable safety regulations.
Note: This machine is for off-road use only and is not designed or approved for highway travel
Identification
Each machine is fitted with a serial plate (shown below) which details the
following:
1. Model
2. Date of Manufacture (DOM)
3. Serial Number
4. Mass
When enquiring regarding spares or additional equipment, ensure you have this information to hand.
Implement Decals
If your implement does not contain all of the safety decals shown below, please contact Chapman Machinery for replacement decals before use.
Note: All decals must be present and visible. It is imperative that these are replaced if damaged to prevent potential harm to users.
1. CAUTION - Read operators manual before handling this machine. Observe instructions and safety rules when operating.
2. WARNING - Attach support before getting into hazardous area.
3. WARNING - Never reach into the crushing danger area as long as parts may move.
4. WARNING - Avoid fluid escaping under pressure. Consult technical manual for service procedures.
1 2
Page 3
3 4
English