RCA RSWL1 Guia De Instalacion página 5

Option 2: Drywall screws with anchors (included)
1. Place the mounting template(s) on the wall where you want to mount the
control unit and/or smart module. IMPORTANT: Make sure there are no
electrical wires where you plan to drill.
2. Draw x's on the wall where indicated by the mounting template(s). Drill a
1/4" pilot hole at each x for the anchors. Tap in gently as needed.
3. Install the dry-wall anchors at the marked location with a #2 Phillips
screwdriver
4. Mount the drywall screws in the anchors. Leave some space between the
screw heads and the wall so that you can mount the control unit and/or
smart module on the screws.
5. Mount the control unit and/or smart module on the screws.
Option 3: Masonry screws (included)
1. Place the mounting template(s) on the wall where you want to mount the
control unit and/or smart module.
2. Draw x's on the wall where indicated by the mounting template(s).
3. Use a 5/32" masonry drill bit to drill pilot holes where you marked the x's.
The holes should be about 1-1/2" deep.
4. Mount the masonry screws where you drilled the pilot holes. Leave some
space between the screw heads and the wall so that you can mount the
control unit and/or smart module on the screws.
5. Mount the control unit and/or smart module on the screws.
Smart Module Control Unit
Mounting Template Mounting Template
MOUNTING TEMPLATE
MOUNTING TEMPLATE FOR THE CONTROL UNIT
45mm(1.77")
50.8mm ( 2 ")
USE FOR FLAT
USE FOR FLAT
WALL MOUNT ONLY
WALL MOUNT ONLY
87.5mm ( 3.45")
72mm(2.83")
Drywall
screws
Masonry
screws
5