Publicidad
Idiomas disponibles
Idiomas disponibles
[] FAQ
. Check the antenna
or cable connection
to the main unit.
. Check the batteries
of the remote control.
. Check if there is an obstacle
between
the infrared
sensor window
and the
remote control.
. Test the signal output.
If OK, then possible infrared sensor trouble.
(Refer to"lR Signal Check" on page 37.)
My remote control
does not work.
. Aim the remote control directly
at the infrared sensor window
on the
What should
I do?
front of the unit.
. Reduce the distance to the unit.
. Re-insert the batteries
with their polarities
(+/- signs) as indicated.
. When there is an infrared-equipped
device such as PC near this unit, it
may interrupt
the remote control
signal of this unit.
. Move the infrared-equipped
device away from this unit, change the angle
of the infrared sensor or turn offthe
infrared communication
function.
HOW come the Initial setuP appeais
everY
; connect
theRE coaxial Cable to the Unit directly
and run the initial SetuPl
time I turn on this unit?
,Make
sure to complete
the channel
scan before turning
off the unit.
. Make sure autoscan
has been completed.
(Refer to"Autoscan"
on page 18.)
. Autoscan
must be completed
when you set up the unit for the first
time or move it to a location
where previously
unavailable
channels
are
broadcast.
. The selected channel
may not be broadcasting.
Why I cannot watch some TV programs.
. When autoscan
is interrupted
and not completed,
some channels
will not be received. Make sure to complete.
(Refer to"Autoscan"
on page 18.)
. The selected channel
cannot
be viewed by the"Child
Lock"setting.
(Refer to"Child
Lock" on page 26.)
. The unit requires some kind of antenna
input. An indoor antenna
(VHF
/UHF), an external antenna
(UHF/VHF)
or an RF coaxial cable from your
wall cable/satellite
box needs to be plugged
into the unit.
,CheCk if the fight
input mode i_y
pressing
[INPUT SELECT] o r
using [CH A/Y].
(Refer to"Switching
Each Input
Modei'on
page 15.)
How come there is no image from the
' Check the antenna
or Cable Connection to the unit.
€onnected
external
devices?
', when using the ComPosite
Video Connection
Check that _he Green
(Y), Blue (Pb/Cb) and Red (Pr/Cr) connectors
are connected
to their
corresponding
colored jacks on the unit,
Whenever
I entered
channel
number,
it changes automatically.
Why are captions
not displayed
entirely?
Or, captions
are delayed
behind the
dialogue.
. Many digital channels
have alternate
channel
numbers.The
unit changes
the numbers
automatically
to the ones signifying
the broadcasting
stations. These are the numbers
used for analog broadcasts.
_ Cap_ions that are delayed afew seconds behind the actua! clialogue
are
common
for live broadcasts_ Most captioning
production
companies
can
display a dialogue
to maximum
of 220 words per minutel
If a dialogue
exceeds
that rate, selective editing
is used to insure that the captions
'
remain up_todatewiththecurrentTVscreendialogue.
How can I set the clock ?
. There is no clock function
on this unit.
EN
Publicidad
