Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
POWER BUTTON (HIGH/LOW/HIGH-SINGLE PANEL/
LOW-SINGLE PANEL/OFF)
See Figure 4, page 10.
The panel light will be in the OFF position until the power
button is pressed.
z Connect the product to an AC or DC power supply.
z Press and release the button to cycle between High, Low,
High-Single Panel, Low-Single Panel, and Off.
z Or, when light is off, hold the power button 2 seconds to
go straight to low mode. When light is on, hold the power
button to turn off right away.
NOTE: This light is equipped with a low voltage indicator. If
the light flashes 3 times while a battery pack is installed, this
indicates a low charge condition. Install a charged battery
pack and resume operation.
WARNING:
Hybrid tools are always in operating condition. There-
fore, unit should always be in the OFF status, with the
battery pack removed and power cord disconnected,
when not in use. Do not leave light on while unattended.
Failure to follow these instructions could result in serious
personal injury.
WARNING:
Keep panel light away from combustible materials. If
wrapped or in contact with fabrics, the panel light lens
can produce sufficient heat to melt some fabrics. To
avoid serious personal injury, never allow the panel light
lens to come in contact with anything.
ADJUSTABLE PANEL
See Figure 5, page 10.
CAUTION:
Do not place hands or fingers between top panel and
bottom panel when positioning panel light to avoid
pinching your fingers or hands.
The adjustable panel can be set in a variety of positions.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 8
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
ILLUSTRATIONS START ON PAGE 9.
7 – English
MOUNTING/HANGING THE PANEL LIGHT
See Figures 5 - 6, page 10.
In addition to sitting upright on its base on a flat surface, the
panel light offers a variety of hanging and mounting options in
both the vertical and horizontal position to suit your specific
location and needs.
NOTE: Be careful not to position the panel light in such a
way that prevents normal operation or damages the cord.
WARNING:
Only hang or mount LED panel light in an area where no
electrical wires, utility cables, pipes, or other obstruc-
tions are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang panel
light from any electrical power cord. Ensure panel light is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
Hanging the panel light using the keyholes:
z Install two screws approximately 2.5 in. apart.
z Place the wide portion of the keyholes over the heads
of screws.
z Slide the panel light down until the screws are inside
the narrow portion of the keyholes and the panel light
is secure.
Mounting the panel light to a tripod using the tripod
mounting hole:
z Place the panel light on the 1/4 in. tripod mounting screw.
Make sure the mounting hole on the base of the panel
light seats completely on the mounting screw.
z Turn the panel light clockwise to secure.
Publicidad
