Publicidad
Idiomas disponibles
Idiomas disponibles
Displaying the
hardware and
software versi-
ons
Displaying the hardware and software versions
Tuning the remo-
te control to the
power source
Tuning the remote control
Tuning the remo-
When the remote control first comes into contact with the workpiece, 'pos'
te control to the
or 'neg' will appear on the display for approx. one second:
power source
Matching the
The contact surface "=" transfers the current value of the remote control to the
power source
power source. This is necessary if the welding current has been adjusted in the
with the remote
interim using the adjuster on the power source. Each press on the "-" contact
control
surface or the "+" contact surface directly changes the current at the power sup-
ply.
10
(1)
(2)
Grounding (earthing) cable connected to the "-" current socket
Grounding (earthing) cable connected to the "+" current socket
The hardware and software versions of
the remote control can be displayed by
short-circuiting 2 of the contact sur-
faces.
(1)
Left contact surfaces ( - and =)
shortcircuited
... displays the current hardware
version
(2)
Right contact surfaces ( = and
+) short-circuited
... displays the current software
version
IMPORTANT! To ensure the welding
current is set correctly, the remote
control must be tuned to the power
source:
Clamp the supplied jumper in the
1
rod electrode holder
Short circuit all 3 contact surfaces
2
( -, = and +)
... Switchover between TP 2500
(10-250 A) and TP 3500
Publicidad
