Change The Batteries Of The Head Slide; Maintenance - Seca 284 Manual De Instrucciones Y Garantía

9.2 Change the batteries of the head slide

10.MAINTENANCE

You require 4 Mignon batteries, type AA, 1.5 volt. To
connect the power supply for the head slide, proceed
as follows:
1. Remove the cover of the battery compartment.
2. Remove the battery holder from the battery
compartment.
3. Remove the spent batteries from the battery holder.
4. Insert the new batteries in the battery holder.
NOTE
Observe correct polarity of batteries (markings
on battery holder).
5. Insert the battery holder into the battery
compartment.
ATTENTION!
Damage to device and malfunction due to
clamped or pinched cable
– Lay the battery cable before closing the
battery compartment so that it cannot get
clamped between the cover and the battery
compartment.
6. Slide the cover onto the battery compartment until
it audibly latches into position.
Your seca device leaves the factory with an accuracy
greater than ± 0.15 %. To preserve this level of
accuracy the product must be set up carefully and
serviced regularly.
We recommend having it serviced every 3 to 5 years
depending on how often the scales are used.
ATTENTION!
Incorrect measurements due to improper
servicing
– Make sure that maintenance and repair are
only carried out by an authorised service
partner.
– You can find your local service partner at
www.seca.com or send an e-mail to
service@seca.com.
English
Maintenance • 117