Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
The operation of any utility vac can
result in foreign objects being blown into the eyes,
which can result in severe eye injury. Always wear
safety goggles complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting operation.
CAUTION: To reduce risk of hearing damage,
wear ear protectors when using the vacuum for
extended hours or when using it in a noisy area.
MOUNTING WALL BRACKET
Mount the wall bracket to a wall stud. Secure with
hardware provided.
WARNING: An inadequately mounted wall
bracket could become loose and fall, causing injury
or damage to the wet/dry vacuum. The location used
to mount the wall bracket should be strong enough
to hold the combined weight of the vacuum and
accessories.
CAUTION: The location used to mount
the wall bracket should be strong enough to hold the
combined weight of the vacuum and accessories.
WARNING: Never operate the vacuum without
filters installed.
DRY PICK-UP
INSTALLING THE FOAM FILTER
1. Installing the foam filter will help to protect the
motor and minimize the potential for misting
that may appear in the exhaust air or dripping
of liquid around the lid.
INSTALLING THE REUSABLE FILTER
2. The reusable filter must always be in correct
position to reduce the risk of leaks and possible
damage to vac. Make sure that the reusable filter
is completely covering the filter cage. Attach the
clamp ring and press it down to lock this reusable
filter. Make sure there are no gaps between the
reusable filter and the lid (See illustration). It is
very important to assemble the reusable filter to
the cage without any possible leaks or tears. Any
leaks will allow the picked up debris to be blown
out of the blower port and back into the
surrounding environment.
3. When using the vac to pick up fine dust, it will be
necessary to empty the dust tank and clean or
replace the filter at more frequent intervals to
maintain peak vac performance.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the hose. Twist slightly to tighten the connection.
7. Plug the cord into the wall outlet. The vacuum is
ready for use.
8. Turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
REMEMBER! The foam filter and reusable dry filter
with ring must be installed for dry pick up.
NOTICE:
A dry filter is necessary to pick up dry material. If
use the vac to pick up dust when the filter is wet,
the filter will clog quickly and be very difficult to
clean. If the filter gets wet, replace it before
continuing to do dry pickups.
5
ENGLISH
Publicidad
