Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
4. Insert the hose end into inlet of tank.
5. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the hose. Twist slightly to tighten the connection.
6. Attach one of the cleaning accessories
(depending on the cleaning requirements) to the
extension wands. Twist slightly to tighten the
connection.
7. Plug the cord into the wall outlet. The cleaner is
ready for use.
8. Turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
NOTICE:
WET PICK-UP ACCESSORIES SHOULD BE WASHED
PERIODICALLY, ESPECIALLY AFTER PICKING UP
WET, STICKY FLUIDS OR SPILLS. THIS CAN BE
ACCOMPLISHED WITH A WARM SOLUTION OF
SOAP AND WATER.
This wet/dry vac is equipped with a float
mechanism which will rise automatically to cut
off the airflow when the liquid in the tank reaches
a predetermined level. When this happens, turn off
vac, unplug the power cord, and empty the dust
tank. You will know that the float has shut the
airflow off because the suction ceases and the
motor noise becomes higher in pitch due to
increased motor speed. The liquid capacity may
vary with the rate of pickup.
IMPORTANT！
To reduce the risk of damage to the vac, do not run
motor with float in raised position.
NOTICE:
IF ACCIDENTALLY TIPPED OVER, THE VACUUM
COULD CLOSED SUCTION. IF THIS OCCURS,
PLACE VAC IN UPRIGHT POSITION AND TURN
SWITCH OFF. THIS WILL ALLOW THE FLOAT TO
RETURN TO ITS NORMAL POSITION, AND YOU
WILL BE ABLE TO CONTINUE OPERATION.
EMPTYING THE TANK
WARNING: To reduce the risk of injury from
accidental starting, unplug power cord before
emptying the dust tank.
1. Remove the power head assembly of the wet/dry
vac by pulling outward on the lid clips located on
each side of the vac.Lift off the power head
assembly.
2. Dump the tank contents into the proper waste
disposal container.
6
Publicidad
