Publicidad
SIEMPRE OBSERVE que ESTAS MEDIDAS DE SEGURIDAD AL
OPERAR SU HORNO de la SEGURIDAD
Siempre Lea todas las instrucciones antes de operar
Siempre Sitüe su horno lejos de muebles o afloje cortinas colgantes.
Siempre Mantenga la parrilla trasera lejos de paredes o cortinas por no
bloquear la toma de aire.
Siempre Desenchufe horno cuando no en uso
Siempre
Utilice horno en una superficie seca plana
Siempre
Utilice en 110-120 voltio 60 alimentación de Hz C.A.
Siempre Dirija la cuerda tan no será pisado tropezado sobre ni
pellizcado por muebles
Siempre Mantenga cuerdas eléctricas, las cortinas y otro mobiliario
lejos de su horno
Siempre
Mantenga su horno limpia y el filtro libre de polvo
Siempre _ Utilice dentro sólo
16.
Itis normal for the plug to feel warm to the touch; however, a loose fit between the
AC outlet (receptacle) and plug may cause overheating and distortion of the plug.
Contact a qualified electrician to replace loose or worn outlet.
"SAVE THESE INSTRUCTIONS"
PLEASE READ BEFORE OPERATING
PRE-OPERATING INSTRUCTIONS
1.
Carefully remove your heater from box. (Please SAVE the Box for off
season storage.
2.
Attach the handle using the screws provided.
3.
Make sure the heater is switched OFF before plugging the heater into
the outlet. Connect to properly grounded outlets only. Note: The power
cord has a polarized plug (with one blade wider than the other) that will
only fit in a polarized outlet one way. If it does not insert easily try
reversing the plug. If it still does not fit contact your electrician to replace
your outlet. DO NOT defeat the safety purpose of the polarized plug.
4.
Place heater only on a firm level surface, free from obstructions and at
least 3 ft. away from any wall or other objects such as curtains, plants,
etc.
5.
Avoid overloading your circuit by not using other high wattage
appliances in the same outlet.
HOW TO USE YOUR HEATER
1.
Completely uncoil the cord and plug heater directly into a 110-120 Volt
grounded AC wall outlet. Be sure the plug fits tightly. A loose fit will
cause overheating and damage the plug. Plug and cord may feel warm
during normal usage.
2.
Choose your Power Setting:
High, Low, Fan or OFF. Use the HIGH setting to warm the room quickly.
After your comfort level has been achieved you may want to switch to
the LOW setting to conserve electricity.
3.
Thermostat: Turn to highest setting until room is comfortable. Then
slowly rotate the knob counter clockwise (left) until the heater cycles
OFF. At this SET POINT the heater will cycle On and Off to maintain
this comfort level.
FAN ONLY OPERATION
Simply turn the control knob to the FAN setting to enjoy the gentle
breeze.
CAUTION
Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause FIRE, ELECTRIC
SHOCK
or injury to persons.
Publicidad
