Technaxx TX-157 Instrucciones De Funcionamiento Originales página 2

⚫Connect the Technaxx Battery air compressor TX-157 with one of the
charging cables and load the item fully. The normal charging time is 4
hours⚫Connect one end of the tire inflation joint to the air cylinder and the
other end to the tire valve, use correct adapter type.⚫ Note that the order
of the connections is important; at the same time, note that there are two
types of adapters, American and French.⚫When the power button is
pressed, the LCD display start⚫Press again to start select one of the four
units of PSI, BAR, KAP, KG/CM. ⚫Select the unit you want, set the button
to set the air pressure value you need, and finally press the power button.
⚫The compressor starts.⚫ The setting button adjust the pressure the
pressure value flashes for 4 seconds, is automatically set, or can be set
by pressing the switch. ⚫Press the power switch, when the inflation
pressure reaches the pressure value you set, the smart air cylinder will
automatically stop, but the LED light is still on, then press the power switch
to turn off the light.⚫ When the inflation is over, the tire inflation joint is
quickly unscrewed from the valve core or the counterclockwise. Before the
screwing out, Attention, some parts could be hot. If there is a small leak in
the moment of screwing out the joint, it is normal.
Product overview
1. Pressure Display
2. On/off
3. Battery Level
Top
4. Setting button
5. Charging ports
6. Power and LED button