MOOV MP10AI Manual Del Usuario página 14

according to the set running capacity or flow rate. If the set time period does not contain the current time,
the timer number
controller and flash,
successful timer setting.
All 4 time periods should be set in chronological order. Overlap setting of time will be considered as invalid,
the pump will only run based on the previous valid setting. If all 4 time periods set by the timer are invalid,
and
period again to make sure they are valid.
During timer setting, if you want to return to the previous setting, hold both
you don't need to set all 4 timers, you can hold
the current set value and activate the timer mode.
5.8 Winterizing
In cold climate environments where the pools are closed for winter, the pump must be drained from
the strainer and the pump housing. Both unions must be disconnected and the pump may be
covered and protected from the snow fall or disconnected and kept indoor for protection. Warranty
calls on unproper winterization will not be covered by warranty.
5.9 Parameter Setting
Restore factory
setting
Check the
software version
Manual priming
Enter parameter
setting as below
Parameter
Description
Address
(or 1 or 2 or 3 or 4) that is about to start running will be displayed on the
will display the corresponding time period, indicating a
will flash to remind the user, you can press
Under off mode, hold both
Under off mode, hold both
Under on mode hold both
Under off mode, hold both
address does not need to be adjusted, hold both
address
Default
Setting
for 3 seconds, the system will automatically save
for 3 seconds
for 3 seconds
for 3 seconds
for 3 seconds; If current
Setting Range
to reset the time
for 3 seconds. If
to next
1