Operation - HotShot PGF6002-1 Manual De Instrucciones

Step 6
Cover fire bowl (C) with lid (B)� To lock lid (B) in place,
turn clockwise� To unlock, turn counterclockwise�
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor area� Connect
the propane gas tank to the regulator and turn the valve on the unit to the 'OFF' position� Brush a soap and water
mixture on all connections� Turn the gas supply on; if bubbles occur on any connection there may be a leak� If you
smell gas or a leak is discovered turn the gas valve off, disconnect propane gas tank and do not use the appliance
until the leak is repaired.
Do not use the heating unit without inspecting the gas hose� If there are signs of wear
or abrasion you must replace the hose (if applicable)� Pumice stones/lava rocks/
LavaGlass® could pop up and strike somebody's face during the process of lighting
this unit; stand away from the unit for the first 20 minutes after igniting�
Flame should be a yellow/blue color and between 2 - 10 inches in height�
Wait 50 minutes after extinguishing flame prior to placing
a lid (if applicable) or protective cover on the heating item�
To Light
1� Be sure to remove the lid before lighting the firepit�
2� To light the firepit, push and turn the control knob (D) on the side of the body (C) counterclockwise to ignite the
piezo ignition� It may take several attempts to light the ignition�
3� To adjust the flame, turn the control knob (D) either clockwise or counterclockwise depending whether you
want to lower or raise the flame�
ASSEMBLY INSTRUCTIONS
LOCK
C
B
UNLOCK

OPERATION

10 in.
25 cm
1 in.
5 cm
10